Celto Accoustique P4.14

  • Model: AMPDCEP414
  • Shipping Weight: 20kg
  • 0 Units in Stock

R13508.00

Add to Cart:

Power :

4x 800W 8 ohm

4x 1400W 4 ohm

Overall gain: 34dB (50 times voltage)

Sensitivity at 8 ohms: 1.8 Vrms (+ 6.3dBu)

Signal to Noise Ratio (A weighted, 0dB):> 110dB

Frequency Response (-1dB): 10 - 25,000 Hz

Typical THD (half power, 1kHz, 8 ohms): <0.05%

Typical IMD (1kHz at 4: 1, -20dB): <0.2%

Crosstalk (1kHz):> 70 dB

Slew Rate:> 20V / us

Input Impedance: 20 k?

Damping factor (1kHz, 8 ohms):> 800

Protections: Soft-Start, Short-Circuit, Over and Under-Voltage, Over-Current, Over-Load, DC Output, Temperature, SOM (Smart Overhead Management) )

Operating Voltage: 190 ~ 260VAC 50-60Hz

Preamp: Proprietary PureSound Circuit for Unmatched Sound Quality (Audiophile Capacitors in Signal Path, High Voltage Opamps, Ultra Low Noise Design), Studio Grade VCA Limit, Continuous Protection, RF Protection, Overload Protection

Power Supply (PSU): Advanced Linear topology with current tracking, 105 C long life capacitors capacitors

Output stage: Fully Discrete 4th generation Class D proprietary (93% efficiency at full power)

Half bridge design with High-Speed ??MOSFETs, 105C Long Life capacitors

Cooling: SUNON MagLev fans (50 000 hours dustproof), FEA optimized Radial heat sink for maximum heat transfer

Rear Panel

Speakon Wiring

4 NEUTRIK XLR Input with latch,

4 NEUTRIK XLR Link

4 NEUTRIK Speakon NL4

Stereo / Parallel / Bridge switch

Power cable directly soldered (3x1.5mm without molded plugl)

Speakon Wiring

SPK1 = 1 + 1- CH A / 2+ 2- CH B

SPK2 = 1 + 1- CH B / 2 + 2- Not Used

Dimensions

Frame: 19 "2U height, 388mm total depth

Weight: 18.5 kgs


This product was added to our catalog on Friday 26 April, 2019.

Your IP Address is: 3.80.4.76
Copyright © 2019 PQSound. Powered by Zen Cart